The water pump does not run after power supply on, it is called "locking", which is the most common situation of wall-hung boiler water pump. It often occurs after the wall-hung boiler has not been running for a long time. 1. Locate a large screw on the top of the water pump and use a large "one" screw to loosen it. Then use a suitable screw to loosen the inner shaft slowly. After you feel the jam...
After a non-heating season, the heating pipes of wall-hung boilers are left unused which is likely to produce impurities after rust and microbial precipitation. Water pump is a precision component inside the wall-hung boiler. These impurities can easily hinder the operation of the water pump, causing it to jam, increase noise, or even damage it. The ideal solution is to release and clean the water...
Shinhoo wall hung gas boiler pump works with wet rotor structure by using asynchronous motor and power supply of AC 230V/50HZ.The pump assembled on the hydraulic module of wall hung gas boiler is applied to heating system. IT is composed of stator, rotor, shield cover, vent valve and so on. 1.Sealing: stator and rotor sealed up with stainless steel shield cover, integral structure sealed up withhe...
High efficiency gas boiler pump is one of the most famous high efficiency pump in Shinhoo. It is operated by using permanent magnet asynchronous motor and power supply of AC230V/50Hz. The efficiency can achieve A- class energy saving standard. The bearing is lubricated by circulated liquid. Compact structure design, integrated frequency convert and control with a variety of modes, make the i...
AS one of the most famous water circulation pump factory,Shinhoo offers a very flexible standard program of component solutions, including circulator pumps, motors, cables, connectors, control systems, etc. These standard components can be mixed and matched to thousands of different product variants. So in most cases we are able to meet your requirements with standard solution. If our standard sol...
There are mainly four reasons that cause canned motor pump can not pump water 1. Water or air leakage in the pipeline: The nut may not be tightened tightly during installation. If the leakage is not serious, apply cement or cement slurry mixed with asphalt oil on the leaking or leaking place. Serious water leakage must be re-disassembled. 2. The water circulator...
The impeller is an important accessory of the canned pump, and its shape, size, processing technology, etc. have a decisive influence on the performance of the water circulator pump. The function of the impeller is to transfer the energy input from the prime mover to the liquid. There are three main structural forms of water pump impellers: those with front and rear cover plates are called closed ...
Heat pump is a device that transfers heat energy from a low-level heat source to a high-level heat source. It is a energy-saving high-efficiency device that makes full use of low-grade heat energy. It is a new energy technology that attracts much attention all over the world. As we all know, heat can be transferred spontaneously from high-temperature objects to low-temperature objects, but not in ...
IPv6 